Pontiac GTO Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
Hello-

Does the dash wiring harness route in front of or behind the upright bars that support the steering column bracket? This car it is routed in front of the bars and things are really tight. It is an AC car so I don't want the wiring in the way of the ductwork either.

Thank you,
Andrew
 

·
Registered
Joined
·
637 Posts
The main dash harness is/should be tightly set-in/retained close to the gauges on the panel/bezel not behind the pedal/column supports.
This allows removal of the full dash/gauge assembly with harness attached.
I never understood why so many reach up under and unplug all the lights/connectors to remove the dash assembly rather then just disconnect,
the fuse block at the firewall and remove it all just like the way it went in ??
 
1 - 3 of 3 Posts
Top